Connecting Speakers; Connecting The Speaker Cables - Denon PMA-50 Owner's Manual

Contents Connections

Connecting speakers

NOTE
0 Disconnect this unit's power plug from the power outlet before connecting the
speakers. Also, turn off the subwoofer.
0 Connect so that the speaker cable core wires do not protrude from the speaker
terminal. The protection circuit may be activated if the core wires touch the rear
panel or if the + and - sides touch each other. ("Connecting the speaker
cables" (v p. 17))
0 Never touch the speaker terminals while the power cord is connected. Doing so
could result in electric shock.
0 Use speakers with impedance of 4 - 16 Ω/ohms.
o Connecting the speaker cables
Carefully check the left (L) and right (R) channels on the speakers being
connected to this unit, and be sure to connect the polarities correctly.
1
Peel off about 3/8 inch (10 mm) of sheathing from the
tip of the speaker cable, then either twist the core wire
tightly or terminate it.
Front panel Display
Playback Setting procedure
2
Turn the speaker terminal counterclockwise to loosen
it.
3
Insert the speaker cable's core wire to the hilt into the
speaker terminal.
4
Turn the speaker terminal clockwise to tighten it.
When using banana plugs, rotate the terminals clockwise to tighten them before
inserting the banana plugs.
Rear panel 17
Tips
Remote Index
Appendix