Advertisement
n
Removing the CD changer unit
Prior to performing the following procedures, remove
n
the top cover and both sides BOARD.
[Caution]
Although the CD mechanism unit can be
removed without removing the CD tray
panel, it is still recommended to remove it
in order to prevent damage.
a. From the front panel side of this set, push in the sections
marked with arrows and pull out the CD tray toward
the front.
b. Remove the CD tray panel by pushing both of its
extremities upward in the direction of the arrows.
c. Push the CD tray deep into the set.
1. Disconnect the card wires from the CD PCB CN704,
CN607, CN1101 and disconnect CN1 (shield wire) from
back panel.
2. From the rear of the set, remove the two screws " E "
and two serews " G " on the front panel left and right
side.
3. Handle the CD changer unit rear, take out unit.
1-8
(See Fig.6 and 9)
Fig.6
Advertisement
