Advertisement
n
Removing the cassette deck heads
Prior to performing the following procedures, remove
n
the top cover and both sides board.
Also remove the CD changer unit.
n
Also remove the front panel assembly.
n
1. Remove the five screws " O " that retain the cassette
deck mechanism.
2. Remove the cassette deck mechanism and place it so
that the front side faces up.
3. Remove the solder from the bottom side of the head
terminal and disconnect the wire.
4. Remove the screw " U " that retains the head.
5. Remove the screw " V " that retains the head.
6. Hold the head and slide it in the direction of the arrow
to remove it.
1-16
n
(See Fig.21 to 30)
n
1. Remove the two screws " A " that connect the heat
2. Pull the heat sink outward.
3. Remove the screw " W " that retains the heat sink the
4. Remove the solder fixing the 3-pin regulator.
Removing the 3-pin regulator
Prior to performing the following procedures, remove
the top cover and both sides board.
sink cover to the rear panel.
3-pin terminal regulator Q904,Q907.
(See Q904, Q907, 31)
Fig.31
Advertisement
