Advertisement
<Disassembly of units and assembly inside
this set>
n
Removing the CD PCB
Prior to performing the following procedures, remove
n
the top cover and both sides board.
Also remove the CD changer unit.
n
1. The two screws " E " that retain the VCD assembly
should be removed.
2. Disconnect the wires from CN602, CN603, CN604
and CN605 on the CD PCB, which is located on the
back side of the CD changer unit.
3. The two screws " J " that retain the CD PCB should be
removed.
4. Remove the CD PCB by pulling it toward the side where
the CN601 is located.
5. Using solder, short the CD pickup to connect to short
round.
[Caution]
After re-connecting the wires, be sure to
remove the shorting solder from the GND con-
nection.
6. Disconnect the card wire from the connector CN601
on the main PCB and then remove the main PCB.
1-10
(See Fig.12 and 13)
Advertisement
