Table of Contents
Advertisement
2. Hardware Installation
2. Hardware Installation
The PCNA EP OCe14102 adapter can be connected to fiber optic cables (used with
embedded optical transceivers) or DAC cables. Additional information for these cable
connections and other installation procedures are described in the following sections.
Preparing the Adapter for Installation
Before installing the adapter, you should perform the following steps:
1. Turn off the computer and unplug it.
2. Remove the computer case.
Note: The adapter comes with a low-profile PCIe bracket installed. A hull height
bracket is included in the box with the adapter.
3. For the PCNA EP OCe14102 adapter, if you want to change the bracket to a low
profile version, follow steps 4–12; otherwise, proceed to "Installing the Adapter" on
page 10.
4. The PCNA EP OCe14102 adapter comes with optical transceivers embedded in
their cage assemblies. These optical transceivers must be removed before the
bracket can be removed. If the adapter contains optical transceivers, continue with
the following steps; otherwise, proceed to step 7.
Caution: This is a delicate operation–take care not to damage the optical
The adapter uses different types of optical transceivers. Figure 2-1 shows an
example of one type with the bail (handle) extended.
Figure 2-1 Typical Optical Transceiver
5. To remove a transceiver, pull the bail (handle) out and down to release the latch and
gently pull the transceiver out. Do not force it. After the latch is released, the
transceiver slides out easily.
Figure 2-2 shows a transceiver with the latch released (bail extended) and another
transceiver latched in place.
PCNA EP OCe14102 2x 10Gb
transceiver.
Preparing the Adapter for Installation
Page 8
Advertisement
Table of Contents
