Introduction; Major Features - Fujitsu PCNA EP OCe14102 Installation Manual

1. Introduction

1. Introduction
This manual describes the Fujitsu PCNA EP OCe14102 2x 10Gb PCI-Express adapters
for 10 Gigabits Enhanced Ethernet Fabric of multi-protocol PCI-Express adapters for 10
and 40 Gigabit/sec (Gb/s) Enhanced Ethernet (EE) fabric. This adapter provides
ethernet networking and iSCSI functionality, as well as Fibre Channel over Ethernet
(FCoE) functionality for convergence of Fibre Channel (FC) traffic onto 10 Gigabit EE
fabric.
The PCNA EP OCe14102 is available as a full-featured universal converged network
adapter (UCNA) that supports NIC, iSCSI, and FCoE.
This adapter supports NIC single root I/O virtualization (SR-IOV) and are fully compliant
to the PCI Express CEM Specification Rev. 3.0/2.0/1.1. UCNAs combine two major
functional components: a 10 Gigabit networking MAC and an FC IOC to interface with a
unified lossless Ethernet switch. Adapters serve as a common interface for both
storage and IP traffic retaining familiar FC and networking software stacks, OS drivers,
and management. The supported PCIe connector is an x8.
Illustrations in this manual are only examples. The actual hardware may vary.
Figure 1-1 Fujitsu PCNA EP OCe14102 Adapter

Major Features

Eight PCIe functions, partially configurable to NIC, iSCSI, or FCoE personalities

with offload features
Eight-lane (x8) Generation 3 PCIe interface at 8GT/s, 5GT/s, or 2.5GT/s

(auto-negotiated with system)
Low-profile PCIe form factor PCBA: 6.600 inches by 2.713 inches

Comes with low I/O bracket installed for low-profile cards; optional full height I/O

bracket is included in lose delivery unit.
PCNA EP OCe14102 2x 10Gb
Major Features
Page 4