Disposal; Manufacturer's Warranty - Tools - Hilti TE 3000-AVR Original Operating Instructions

Fault
No hammering action.
The power tool doesn't start or
cuts out during operation and
the LED blinks red.
The power tool doesn't start or
en
cuts out during operation and
the LED lights red constantly.
The power tool doesn't start
and the indicator lamp blinks
yellow.
The power tool doesn't start or
cuts out during operation.
NOTE
If the fault cannot be eliminated by the measures listed above, have the power tool checked by Hilti Service.

10 Disposal

Most of the materials from which Hilti power tools or appliances are manufactured can be recycled. The materials
must be correctly separated before they can be recycled. In many countries, Hilti has already made arrangements for
taking back your old power tools or appliances for recycling. Please ask your Hilti customer service department or
Hilti representative for further information.
For EC countries only
Disposal of electric tools together with household waste is not permissible.
In observance of the European Directive on waste electrical and electronic equipment and its imple-
mentation in accordance with national law, electrical appliances that have reached the end of their life
must be collected separately and returned to an environmentally compatible recycling facility.

11 Manufacturer's warranty - tools

Hilti warrants that the tool supplied is free of defects in
material and workmanship. This warranty is valid so long
as the tool is operated and handled correctly, cleaned
and serviced properly and in accordance with the Hilti
Operating Instructions, and the technical system is main-
tained. This means that only original Hilti consumables,
components and spare parts may be used in the tool.
This warranty provides the free-of-charge repair or re-
placement of defective parts only over the entire lifespan
of the tool. Parts requiring repair or replacement as a
result of normal wear and tear are not covered by this
warranty.
24
Possible cause
A fault has occurred in the power tool.
Temporary fault (e.g. overheating or
overvoltage).
Advance warning of need for servi-
cing.
The power tool has not been un-
locked (power tools with optional theft
protection system).
The extension cord is too long or its
gauge is inadequate.
Additional claims are excluded, unless stringent na-
tional rules prohibit such exclusion. In particular, Hilti
is not obligated for direct, indirect, incidental or con-
sequential damages, losses or expenses in connec-
tion with, or by reason of, the use of, or inability to
use the tool for any purpose. Implied warranties of
merchantability or fitness for a particular purpose are
specifically excluded.
For repair or replacement, send the tool or related parts
immediately upon discovery of the defect to the address
of the local Hilti marketing organization provided.
This constitutes Hilti's entire obligation with regard to
warranty and supersedes all prior or contemporaneous
comments and oral or written agreements concerning
warranties.
Remedy
If necessary, the power tool should be
repaired by Hilti Service.
Release the switch and allow the
power tool to cool down or connect
it to a different electric supply.
Have the power tool serviced or re-
paired by Hilti Service.
Use the TPS key to unlock the power
tool.
Use an extension cord of an
approved length and / or of adequate
gauge.