Door Latch Assembly - Vulcan-Hart C24EO3 Service Manual

C24EO SERIES ELECTRIC COUNTERTOP STEAMERS - REMOVAL AND REPLACEMENT OF PARTS
Fig. 26
4. Install lock nuts and tighten until no gap exists
between handle, step spacer and lock nut. Do not
over-tighten lock nuts.
5. Close inner door panel so that latch mechanism
engages striker on front panel.
6. Install outer door housing onto inner door panel.
7. Align the top and bottom screw holes of outer
door housing with inner door panel.
Fig. 27
8. Apply Loctite 7471 Primer N and Loctite 242 to
threads of screws before assembling.
9. Install screws to secure door halves together.
10. Check opening and closing operation of door.

DOOR LATCH ASSEMBLY

electrical power to the machine and
follow lockout / tagout procedures.
REMOVAL AND DISASSEMBLY
F25386 (0415)
Disconnect the
Page 12 of 27
1. Separate outer door housing assembly from
inner door panel as outlined under DOOR
HANDLE.
2. Remove screws securing latch assembly to inner
door panel and remove latch mechanism.
Fig. 28
3. Remove E-clip from latch assembly pins and pull
pins from latch mechanism.
Fig. 29
4. Remove retaining pin from spring pin.
5. Separate sliding bracket from stationary bracket.
Fig. 30
ASSEMBLY