Remote Power Control - Marantz Model SC-11S1 User Manual

HOW TO USE AND SET FEATURES

REMOTE POWER CONTROL

By connecting this unit to a Marantz SM-11S1 stereo power
amplifier by remote power control, the power supply of the
SM-11S1 can be automatically switched ON/OFF in sync with
this unit's power ON/OFF control. There are 2 trigger output
terminals on this unit, and a maximum of 2 SM-11S1s can be
controlled in sync with this unit's power ON/OFF control.
1.
Prepare the correct number of double-ended mini plug
audio connection cables for the number of SM-11S1s to
be connected. Either of the following types of connection
cables are adequate.
¶ Monaural miniplug ⇔ monaural miniplug connecting
cable
¶ Stereo miniplug ⇔ stereo miniplug connecting cable
Note:
Do not use connecting cables that contain resistance.
SC-11S1
SM-11S1
SM-11S1
2.
After completing the connections shown below, switch the
remote power control ON/OFF switch on the rear panel of
the SM-11S1 to ON.
3.
Press the SM-11S1 POWER ON/OFF switch to switch to
standby mode.
4.
In this condition, press the POWER ON/OFF switch on
this unit, and the power of the SM-11S1 will switch ON in
sync.
Notes:
• The SM-11S1 cannot be controlled if the SM-11S1
remote power control switch is OFF.
• When the power for this unit is switched ON or OFF,
control sync signals are output from TRIGGER OUT 1
and 2.
(However, the TRIGGER OUT 2 power ON control
signal is output approximately 1 second after the
TRIGGER OUT 1 power On control signal output.) )
TRIGGER OUT
AC IN
TRIGGER OUT
1 2
REMOTE POWER CONTROL
REMOTE POWER CONTROL
AC IN
REMOTE POWER CONTROL
REMOTE POWER CONTROL
ON
TRIGGER IN
TRIGGER IN
OFF
AC IN
REMOTE POWER CONTROL
ON
TRIGGER IN
OFF
1 2
ON
OFF
Set to ON
REMOTE POWER CONTROL
ON
OFF
TRIGGER IN
Set to ON
25