Replacing Carbon Brushes - Makita 1600 Instruction Manual

013499
In this condition, hold sharpening holder so that both
blades are brought fully into contact with the dressing
stone. Thus, both blades are sharpened simultaneously
at the same angle.

Replacing carbon brushes

001145
Remove and check the carbon brushes regularly.
Replace when they wear down to the limit mark. Keep
the carbon brushes clean and free to slip in the holders.
Both carbon brushes should be replaced at the same
time. Use only identical carbon brushes.
1
013500
Use a screwdriver to remove the chip cover.
1
2
013501
Use a screwdriver to remove the brush holder caps.
Take out the worn carbon brushes, insert the new ones
and secure the brush holder caps.
1. Limit mark
1
1. Screwdriver
2. Chip cover
2
1. Brush holder
cap
2. Screwdriver
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by Makita Authorized Service Centers,
always using Makita replacement parts.
7