Table of Contents
Advertisement
Wing Part II (cont.)
8. Sand the upper skin of the in-
ner wing panel to a sharp taper.
This will allow the gap seal to
slide under the wing easier.
9. Tape the flaps onto the wings
and install the flap linkages.
Hook up the servos and the wing
inner panels are almost com-
pleted.
10. Slide a piece of sandpaper
between the aileron and top skin
and sand until the aileron leading
edge and the top skin are fairly
sharp edges.
Construction
11. Install the aileron gap seal
tape. Pull down on the aileron
and slide the gap seal tape under
the wing skin using the tip of
your finger.
12. Install the threaded ball link
into the aileron and install the
aileron linkages. Hook up the
aileron servos and the outer pan-
els are almost completed.
Fuselage Part II
Page 19
Super XC
1. Cut the excess material off the
hatch and sand up to but not
touching the outer raised line.
2. Keep sanding and fitting until
the hatch fits snuggly on the fuse-
lage.
3. Put three dabs of 5 minute ep-
oxy on the rear hatch bulkhead
and place the bulkhead 1 1/2"
away from the back edge of the
hatch.
Advertisement
Table of Contents
