DG Airparts Super XC Instruction Manual page 10

Wing Mount (cont.)
4. Using a combination square
and ruler, make a mark at 1 1/4"
for the front hold down bolt and
3/4" for the read hold down bolt.
Make sure and not measure from
the lip of the right panel.
5. Drill a pilot hole in all four
wing bolt locations using a 1/8"
or similar sized drill bit.
6. Set the wings back in the sad-
dle and center the panels with the
fuselage.
Construction
7. Mark the wing and fuselage for
future reference.
8. Hold the wing down in the
proper position and using the
same drill bit you used to drill the
pilot holes, drill the wing saddle.
Page 10
Super XC
9. Remove the drill bit and use it
to hold the wing in position
10. Press a push pin along the
seam line near the fin and use it
to hold a tape measure.
11. Measure to the tip of the in-
ner wing panel and adjust the
wing so that both the left and
right measurements are the same.