Table of Contents
Advertisement
PC Input Terminals connection
Notes:
• Due to space limitations, occasionally you may have trouble connecting Mini D-sub 15P cable with ferrite core to PC input
Terminal.
• With regard to the typical PC input signals that are described in the applicable input signals list (see page 49), adjustment
values such as for the standard picture positions and sizes have already been stored in this unit. You can add up to eight
PC input signal types that are not included in the list.
• Computer signals which can be input are those with a horizontal scanning frequency of 15 to 110 kHz and vertical scanning
frequency of 48 to 120 Hz. (However, the image will not be displayed properly if the signals exceed 1,200 lines.)
• The display resolution is a maximum of 1,440 × 1,080 dots when the aspect mode is set to "4:3", and 1,920 × 1,080
dots when the aspect mode is set to "16:9". If the display resolution exceeds these maximums, it may not be possible
to show fi ne detail with suffi cient clarity.
• The PC input terminals are DDC2B-compatible. If the computer being connected is not DDC2B-compatible, you will
need to make setting changes to the computer at the time of connection.
• Some PC models cannot be connected to the set.
• There is no need to use an adapter for computers with DOS/V compatible Mini D-sub 15P terminal.
• The computer shown in the illustration is for example purposes only.
• Additional equipment and cables shown are not supplied with this set.
• Do not set the horizontal and vertical scanning frequencies for PC signals which are above or below the specifi ed
frequency range.
• Component Input is possible with the pin 1, 2, 3 of the Mini D-sub 15P Connector.
• To use sync input VBS signals, use the connector which incorporates a 75-ohm termination resistance and which is
available on the market, for the connection of the HD connector where the VBS signals are to be input.
• Change the "Component/RGB-in select" setting in the "Setup" menu to "Component"
(when Component signal connection) or "RGB" (when RGB signal connection). (see page 37)
Signal Names for Mini D-sub 15P Connector
5
4
3
2
1
10
9
8
7
6
15 14 13 12 11
Pin Layout for PC Input
Terminal
COMPUTER
Conversion adapter
(if necessary)
Connect a cable which matches
the audio output terminal on the computer.
Pin No.
Signal Name
R (P
/C
1
R
G (Y)
2
B (P
/C
3
B
NC (not connected)
4
GND (Ground)
5
TH-42PS9
RGB
PC cable
Audio
Pin No.
Signal Name
)
GND (Ground)
6
R
GND (Ground)
7
)
GND (Ground)
8
B
+5 V DC
9
GND (Ground)
10
Connections
(Female)
AUDIO
PC IN
Mini D-sub 15p
(Male)
Stereo plug
Pin No.
Signal Name
NC (not connected)
11
SDA
12
HD/SYNC
13
VD
14
SCL
15
9
Hide quick links:
Advertisement
Table of Contents
