Names Of The Buttons And The Display - Daiwa Seaborg 500MR Operating Instructions Manual

Names of the buttons and the display

MODE BUTTON
1
Press the MODE BUTTON
Hold the button down for at least two seconds before scrolling to prevent operational mistakes.
- Use the Power Lever to adjust numeric values.
- Pressing the MODE BUTTON
- Depress and hold the MODE BUTTON
- Mode change cannot be done while line is being fed.
RESET BUTTON
2
This button resets the depth counter to zero.
Make sure to press this button before you start fishing. The reset depth is used to make the auto stop function
work. (display shows
The RESET BUTTON must be quickly pressed 3 times within 2 seconds. This prevents accidental resetting. For a
total reset, when line has been broken off, press and hold the button for at least 2 seconds.
INVERSE COUNTER BUTTON
3
Pressing this button resets the counter in the lower area of the display.
- It memorizes distance from the bottom, handy for dropping a bait right back into the strike zone after youʼve been bit.
- The chumming timer resumes after pressing this button.
to scroll through the adjustment displays for each reel function.
sets the numeric values you have adjusted.
to return to the depth display.
). The default setting of auto stop is 2 meters.
MODE BUTTON
1
RESET BUTTON
2
SPEED/POWER RANGE INDICATOR
5
INVERSE COUNTER BUTTON
3
5 SHIFT BUTTON
JIG/PICKUP BUTTON
4
Mode display
6
Depth counter
7
Inverse counter
8
(winding speed display)
Mode display
6
Jigging display
9
Chumming timer
10
(Power indicator, time to wind up,
timer display)
6