JVC LT-19D200 Service Manual page 16

4.8 HOW TO INITIALIZE THE LCD TV/DVD
The purpose of initialization is to place the set in a new out of box condition. The customer will be prompted to
select a language and program channels after the set has been initialized.
To put the program back at the factory-default, initialize the LCD TV/DVD using the following procedure.
4.8.1 DVD SECTION
Turn the power on.
(1)
(2) To enter the service mode, press the service button on the
service remote control unit.
- To cancel the service mode, press [POWER] button on
the service remote control unit.
(3) To put the LCD TV/DVD into the DVD mode, press [CH RE-
TURN] on the remote control unit.
(4) To put the LCD TV/DVD into the Flash clear mode, press
[INPUT SELECT] buttons on the remote control unit in that
order within five seconds. The following screen appears.
Flash Memory Clear : OK
CHUCKING ON
When "OK" appears on the screen, the factory default will
be set.
(5) To exit this mode, press[CHANNEL UP/DOWN] button to
go to TV mode, or press [POWER] button to turn the power
off.
1-16 (No.YA711<Rev.002>)
4.8.2 LCD TV SECTION
(1) Turn the power on.
(2) To enter the service mode, press the service button on the
service remote control unit.
- To cancel the service mode, press [POWER] button on
the service remote control unit.
(3) Press [INFO] button on the service remote control unit to
initialize the LCD television.
(4) "INITIALIZED" will appear in the upper right of the screen.
"INITIALIZED" color will change to green from red when ini-
tializing is complete.