Settings; Programming The Sound Bar With The Tv's Remote Control (Tv's Remote Control Learning Function) - Yamaha YAS-105 Owner's Manual

Settings

Programming the sound bar with the TV's remote
control (TV's remote control learning function)
Once you program the sound bar, you can control it with your TV's remote control for
functions such as turning on/off the TV and sound bar simultaneously, or volume up/
down and muting/unmuting of the sound bar.
• This function is available only when your TV's remote control uses IR (infrared) signal.
• A radio wave remote control will not work.
• If by changing the volume of the sound bar the TV's volume also changes, set the TV's volume to
minimum, or disable speaker output.
1
Turn off the TV.
2
Turn off the sound bar.
3
Hold down the LEARN key on the sound bar's remote control for
more than 3 seconds while pointing at the appropriate remote
control sensor (p.5).
The sound bar enters the learning mode, and the indicators on the top panel flash
as shown below.
LEARN BLUETOOTH
STANDBY
4
Check if the appropriate remote control sensor has been activated.
You can check which remote control sensor has been activated with the CLEAR
VOICE indicator.
CLEAR VOICE Activated remote control
indicator sensor
Off On the front panel
CLEAR
VOICE
Lights up On the top panel
CLEAR
VOICE
If the appropriate remote control sensor has not been activated, press the LEARN
key to exit from the learning mode, and repeat from Step 3.
12
5
5-1
5-2
Activated remote control
sensor is appropriate when...
Installing the sound bar on a TV
cabinet, etc.
Attaching the sound bar to a
wall
NOTE
• Steps 5 to 8 require only the TV's remote control and the keys on the rear panel of the sound bar.
The remote control of the sound bar is not necessary.
• If the sound bar has already learned functions, the following indicators light up.
Mute: TV
Volume (-): BD/DVD
Volume (+): ANALOG
Power: BLUETOOTH
Teach the sound bar the "Mute" code of the TV's remote control.
Press (mute) on the rear panel of the sound bar.
While pointing your TV's remote control at the remote control sensor, hold
down the mute key for more than 1 second twice or three times.
The appropriate remote control sensor depends on the installation position (p.5).
Approx. 30 cm (1 ft)
Hold down Release
(more than 1 second) (more than 1 second)
Result Bleep/buzzer Indicators
Successfully
Once
learned
Failed to learn
* Repeat from Twice
Step 5-1.
For cable or satellite set top box users:
Use the original TV's IR remote control (not the cable or satellite set top box's remote control) to
program the sound bar.
TV's remote control
Hold down Release
(more than 1 second) (...)
Lights up
Flash