Rheem R95P Installation Instructions Manual page 21

NOTE: REMAINING STEPS SHOWN WITH FURNACE IN DOWN FLOW ORIENTATION
6
1/4" TUBE CUT
TO FIT (APPROX
10-1/2")
6c
6b - INSTALL CONDENSATE TRAP BY MOUNTING BRACKET TO JACKET USING (2) SCREWS
6c - CUT 1/4" VENT TUBE TO FIT (APPROX. 10-1/2"). INSTALL AS SHOWN.
6d - INSTALL HOSE D (REMOVED IN STEP 1) FROM INDUCER COUPLING TO THE FLUE
TAP IN THE CONDENSATE TRAP.
6e - INSTALL HOSE E FROM COLLECTOR BOX TO TOP OF CONDENSATE TRAP.
OPTION: LEFT DRAIN
7
1/8" DRILL
DISCARD
7/8" PLUG
DETERMINE RIGHT OR LEFT DRAIN OPTION.
LOCATE 7/8" HOLE IN JACKET SIDE AND REMOVE PLUG - DISCARD.
DRILL (2) 1/8" HOLES FOR BULKHEAD COUPLING.
9a
OPTION
TUBE C
DRAIN LEFT SIDE
CUT TO FIT
CABINET WIDTH
9a-2
ATTACH SIDE "2" TO BULKHEAD
COUPLING
2
1
NOTE:
USE SOAPY WATER TO FACILITATE EASY
HOSE AND TUBE ASSEMBLY
9a - LEFT SIDE DRAIN OPTION
9a -1- REMOVE HOSE A (FACTORY INSTALLED ON CONDENSATE TRAP) & REPLACE
WITH HOSE B REUSING SUPPLIED CLAMP.
9a -2- CUT TUBE C ON MARKED LINES CORRESPONDING TO CABINET WIDTH.
9a- 3- ROTATE RUBBER HOSE ON TUBE C SO THAT SIDE "1" CONNECTS TO PVC &
SIDE "2" TO BULKHEAD COUPLING. INSTALL CLAMP OVER HOSE ON
BULKHEAD COUPLING.
9a- 4- INSTALL TUBE C USING HOSE CLAMP.
SEE CRITICAL HOSE CLAMP LOCATION NOTE
IN THE GENERAL COVERSION INSTRUCTIONS.
SWAP
ENDS
9a-3
9a-1
HOSE B
(X2)
9a-4
TUBE C
6a
6e
HOSE E
6d
HOSE D
ROTATE INDUCER COUPLING TO ENSURE
DOWNWARD FLOW OF CONDENSATE FROM
FLUE VENTING
6b
NOTE:
USE SOAPY WATER TO FACILITATE EASY
HOSE AND TUBE ASSEMBLY
8
OPTION: RIGHT DRAIN
1/8" DRILL
DISCARD
7/8" PLUG
INSTALL BULKHEAD COUPLING USING (2) SCREWS.
INSTALL IN JACKET WITH THE BARBED FITTING
POINTED INTO THE VESTIBULE.
9b
OPTION
DRAIN RIGHT SIDE
NOTE:
USE SOAPY WATER TO FACILITATE EASY
HOSE AND TUBE ASSEMBLY
9b - RIGHT SIDE DRAIN OPTION
ATTACH HOSE A (FACTORY INSTALLED) TO BULKHEAD COUPLING.
INSTALL CLAMP OVER HOSE ON BULKHEAD COUPLING.
APPROXIMATELY 10-20° TILT
ON INDUCER COUPLING
GROUND
10° -20
INSTALL
HOSE A
ST-A1194-30-X0
21