Advertisement
Service Manual: Whirlpool Oven AKPJ399IX
Connection Instructions
Electrical
Those ovens equipped with a three-pole power supply cable are designed to operate with an alternating
Connection
current. The wire for earthling the appliance is yellow-green in colour.
Fitting on a
Opening the terminal board:
Power
· Using a screwdriver, prize the bolt on the side tabs of the
Supply
terminal board cover ;
Cable
· Unscrew the bolt, pull open the cover of the terminal board.
To install the cable, proceed as follows:
· Remove the wire clamp screw and the three contact screws L-N – (EARTH)
· Fasten the wires beneath the screw heads using the following color
scheme: Blue (N) Brown (L) Yellow-Green (EARTH)· Fasten the supply cable in place with the clamp
and close the cover of the terminal board.
Connecting the supply cable to the mains Install a standardized plug corresponding to the load indicated on the data
plate. When connecting the cable directly to the mains, install an omni polar circuit breaker with a minimum contact
opening of 3 mm between the appliance and the mains. The omni polar circuit breaker should be sized according to the
load and should comply with current regulations (the earth wire should not be interrupted by the circuit breaker). The
supply cable should be positioned so that it does not reach a temperature of more than 50℃ with respect to the room
temperature, anywhere along its length, or protected by insulation sleeping having an appropriate rating. Before making
the connection, check that:
· The electrical safety of this appliance can only be guaranteed if the cooker is correctly and efficiently earthed, in
compliance with regulations on electrical safety. Always ensure that the earthling is efficient; if you have any doubts call
in a qualified technician to check the system. The manufacturer declines all responsibility for damage resulting from a
system which has not been earthed.
· Before plugging the appliance into the mains, check that the specifications indicated on the date plate (on the appliance
and /or packaging) correspond to those of the electrical mains system of your home.
· Check that the electrical capacity of the system and sockets will support the maximum power of the appliance, as
indicated on the data plate. If you have any doubts, call in a qualified technician.
· If the socket and appliance plug are not compatible, have the socket replaced with a suitable model by a qualified
technician. The latter, in particular, will also have to ensure that the cross-section of the socket cables is suitable for the
power absorbed by the appliance. The use of adapters, multiple sockets and /or extensions, is not recommended. If their
use cannot be avoided, remember to use only single or multiple adapters and extensions which comply with current
safety regulations. In these cases, never exceed the maximum current capacity indicated on the single adapter or
extension and the maximum power indicated on the multiple adapter. The plug and socket must be easily accessible.
Version: 2012-07-24
7 |
P a g e
Hide quick links:
Advertisement
