Advertisement
Available languages
Available languages
SIH 90TU
4
Accessories
4.1 Connection flange
The device can optionally be switched to flange connection using
the flat-sealing connection flange.
4.2 Remote control
A remote control adds convenience and is available as a special
accessory. Operation and menu navigation are identical to those
of the heat pump manager. Connection takes place via an inter-
face (special accessories) with RJ 12 Western plug.
NOTE
In the case of heating controllers with a removable operating element,
this can also be used directly as a remote control.
4.3 Building management system
The heat pump manager can be connected to a building man-
agement system network via supplementation of the relevant in-
terface plug-in card. The supplementary installation instructions
of the interface card must be consulted regarding the exact con-
nection and parameterisation of the interface.
The following network connections can be made on the heat
pump manager:
Modbus
EIB, KNX
Ethernet
ATTENTION!
If the heat pump or circulating pumps are controlled externally, an flow
rate switch is required to prevent the compressor from being switched on
when there is no volume flow.
EN-4
5
Transport
For transportation with a sack or vessel truck, it can be mounted
on the front of the device under the transport protection.
The device can be lifted from the rear or front on even ground
using a lift truck or fork-lift truck for transportation. Transport pro-
tection is not compulsory for this.
ATTENTION!
The heat pump must not be tilted more than 45° (in any direction).
After transportation, the transport fastening in the device is to be
removed from both sides of the base.
ATTENTION!
Before start-up, the transport fastening must be removed.
To remove the panelling, open the individual covers by unscrew-
ing the respective turn-lock fasteners and then gently tilting the
covers away from the device. Then lift them up out of the mount-
ings.
452234.66.54 · FD 9401
www.dimplex.de
Advertisement
Chapters
