Manitowoc S1800M Installation Use And Care Manual page 33

Section 4
Water Inlet Valve
The water inlet valve normally does not require removal
for cleaning. Refer to Section 5 for a list of causes for
"No Water Entering Water Trough" or "Water Overflows
Water Trough.
1. When the ice machine is off, the water inlet valve
must completely stop water flow into the machine.
2. When the ice machine is on, the water inlet valve
must allow the proper water flow through it. Set the
toggle switch to ON. Watch for water flow into the ice
machine. If the water flow is slow or only trickles into
the ice machine, refer to Section 5.
Follow the procedure below to remove the water inlet
valve.
Disconnect the electric power to the ice machine
and dispenser at the electric service switch box and
turn off the water supply before proceeding.
1. Remove the 1/4" hex head screws.
2. Remove, clean, and install the filter screen.
FILTER
ACCESS
SCREWS
Part Number 80-1633-3
! Warning
WATER
INLET
VALVE
SV1622
Maintenance
4-11