How To Launch Qdatatrove; Using Qdatatrove In Windows 7; Backing Up Your System; Backing Up Your System Into A Single File - BenQ Joybook L41 Series User Manual

How to launch QDataTrove

You can launch QDataTrove either from Windows
Preinstallation Environment (Windows PE) or Windows 7.
Launching QDataTrove from Windows PE only allows you to
access partial functions of QDataTrove. To utilize the full
functionality of QDataTrove, launch this application from
Windows 7 instead.
Launching QDataTrove from Windows PE
1. Start your Joybook.
2. During system startup, press the <Alt> + <F10> keys when
you see "Press Alt + F10 to enter QDataTrove 3..." on the
upper left part of the screen.
3. After launching QDataTrove, click the
or Create Discs tab to perform the desired operation.
Launching QDataTrove from Windows 7
1. Start your Joybook and boot into Windows 7.
Start All Programs
2. Click >
QDataTrove folder, click
application.
A User Account Control window may pop up asking
whether you want to run QDataTrove, you need to click Yes
in order to proceed.
3. After launching QDataTrove, click the
Create Discs
or tab to perform the desired operation.
Back up Restore
,
BenQ QDataTrove
> > . In the
QDataTrove to launch the
Back up Restore
,
Using QDataTrove in
Windows 7

Backing up your system

• Make sure your system is connected to AC Power before
performing the operation.
• A backup file will occupy a large amount of disk space, so
make sure there is sufficient free space first. The amount of
required space depends on the amount of used space on the
C: drive.

Backing up your system into a single file

QDataTrove allows you to back up your system drive (C: drive)
,
into a single image file, by saving it as a Windows Imaging
Format (WIM) file. It makes an exact copy of your entire system
drive (C: drive), including the operating system, installed
software programs, registry settings, etc. To perform the
operation, follow the steps below:
By default, backup files will be placed under "D:\BenQ
User\System Drive", so make sure your D: drive has sufficient
free space.
1. In QDataTrove, click the
,
2. Click the button to select
Backup to File .
Save As
3. A window pops up. Use the default file name or
specify a preferred file name, and then click
system backup file.
Recovering your system using QDataTrove
Back up
tab.
System Drive Backup -
Save
to create a
41