RAM 2015 ProMaster City Owner's Manual page 81

strap. See the section "Installing Child Restraints
Using the Top Tether Anchorage" for directions to
attach a tether anchor.
9. Test that the child restraint is installed tightly by
pulling back and forth on the child seat at the belt
path. It should not move more than 1 inch (25.4 mm)
in any direction.
Any seat belt system will loosen with time, so check the
belt occasionally, and pull it tight if necessary.
Installing Child Restraints Using The Top Tether
Anchorage — Passenger Wagon Only:
WARNING!
Do not attach a tether strap for a rear-facing car seat
to any location in front of the car seat, including the
seat frame or a tether anchorage. Only attach the
THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 79
tether strap of a rear-facing car seat to the tether
anchorage that is approved for that seating position,
located behind the top of the vehicle seat. See the
section "Lower Anchors and Tethers for CHildren
(LATCH) Restraint System" for the location of ap-
proved tether anchorages in your vehicle.
(Continued)
I n f o r ma t i o n P r o v i d e d b y :
WARNING! (Continued)
2