Before Using - Panasonic PV-D4733S-K Operating Instructions Manual

Dvd/vcr deck
Hide thumbs Also See for PV-D4733S-K:
Table of Contents

Advertisement

Before Using

Congratulations
on your purchase of one of the most
sophisticated and reliable products on the
market today. Used properly, it will bring you
years of enjoyment. Please fill in the
information below. The serial number is on the
tag located on the back of your DECK.
• Date of Purchase
• Dealer Purchased From
• Dealer Address
• Dealer Phone No.
PV-D4733S-K
• Model No.
• Serial No.
Accessories
Remote Control
LSSQ0375
Loading the Batteries
1) Open cover.
2) Insert batteries as
marked.
3) Close cover.
Battery replacement caution
• Do not mix old and new batteries.
• Do not mix alkaline with manganese batteries.
Record/ Playback Time
Only use tapes with the
Type of Video Cassette
Tape Speed
Setting
T60
SP
1 Hour
2 Hours
(Standard Play)
LP
2 Hours 4 Hours
(Long Play)
SLP
3 Hours 6 Hours 8 Hours
(Super Long Play)
4
PV-D4733S-K(E) P1-25 (030314).p65
Head Cleaning
Playing older or damaged tapes may eventually cause
video heads to become clogged.
Video Head Clog Sensor
During playback, this screen
appears if clogging is detected.
To remove screen, press PLAY
on the remote or DECK.
• Use "dry" type head cleaning cassette only.
(Part No. NV-TCL30PT is recommended.)
• Follow cleaning tape instructions carefully.
Excessive use of tape can shorten head life.
• If head clog symptoms persist, contact your
nearest Factory Servicentre or authorized
Servicentre (see p. 59).
Batteries 2 "AA"
Built-in Head Cleaner
A clean video head helps produce a clear picture.
So, we have equipped your DECK with a built-in,
RF Coaxial Cable
non-chemical head cleaning system that helps
LSJA0372
prevent clogging of the video heads.
Cleaning is performed each time you load or unload
a video cassette.
• This feature is preventative only, If your video heads
are seriously clogged, consider the use of a chemical
non-abrasive head cleaning kit or take your DECK to
a Servicenter.
Features for a Quality Picture (VCR)
Digital Auto Picture
Automatically controls the video output signal for
less noise depending on the tape condition.
Digital Auto Tracking
Continuously analyzes the signal and adjusts for
optimum picture quality.
Manual Tracking Control
(to reduce picture noise)
Use during Playback and Slow Motion mode to
reduce picture noise.
Press CH (TRACKING)
or on DECK until the picture clears up.
To return to Auto Tracking, press POWER off, then
on again a few seconds later.
mark in this DECK.
T120
T160
2 Hours
40 Minutes
V-Lock Control (to reduce picture jitter)
In Still mode, CH (TRACKING)
5 Hours
20 Minutes
Lock control.
4
V I DEO HEADS MAY
NEED CLEAN I NG
PLEASE I NSERT HEAD
CLEAN I NG CASSETTE
OR REFER TO MANUAL
END
: PLAY
/
on the remote control
/
operate as a V-
2003/04/09, 13:52

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents