Before Installation; Power Amplifier Unit - Panasonic CQ-DVR909U Operating Instructions Manual

Before Installation

Be sure to remove the Shipping Brackets 1 .

Power Amplifier Unit

Carpet
3 Velcro Tape
When using the shipping bracket 1
2 Tapping screws (Option)
(5 mm·t16 mm)
4 Binding Screw
(5 mm·t12 mm)
Use a knife or
other cutting
tools to open
2 cross-shaped
cuts in the carpet.
Cautions:
≥ Continuous use of this unit will cause the power amplifier unit to become hot. Be careful not to
touch the power amplifier unit while it is in operation. Also, do not place other objects on top of
the power amplifier unit.
≥ Do not install the power amplifier unit in a location where it may be subject to damage from
overheating, such as next to a heater vent, or in a location exposed to direct sunlight such as the
dashboard or the rear window deck.
≥ Do not install the power amplifier unit near a door or other locations where it may be readily
exposed to water or stepped on.
≥ Clean away all oil, moisture, dust, etc., from the surface where the velcro tape is to be applied.
≥ When drilling holes in the car, make certain that you do not damage any pipes or wiring on the
underside of the car.
≥ When installing the power amplifier unit, make sure that the cord is positioned in a location where
it will not be pinched or damaged when the seat slides forward or backward.
2 Power Amplifier
Unit
Pass the cords
under the carpet.
2 Power Amplifier
Unit
1 1 Shipping
Bracket
Apply anti-corrosion treatment
to the 2 Tapping screws
and the 2 holes.
1 Shipping Bracket
Note:
≥ The shipping brackets are sometimes used
when installing the power amplifier unit. Do
not discard the shipping brackets.
Using Velcro Tape 3 , secure the Power Amplifier
Unit 2 underneath the passenger seat.
≥ Affix the adhesive-backed Velcro Tape 3 to the
bottom of the power amplifier unit, and then place
the unit on the carpet under the seat.
Note:
≥ Velcro Tape 3 may not adhere to some types of
carpet.
1 Using a Binding Screw 4 , attach a Shipping
Bracket 1 to the Power Amplifier Unit 2 .
2 Drill two 3.5 mm holes in the body of the car in
alignment with the holes in the Shipping Bracket
1 .
3 Use 2 Tapping screws to attach the Power
Amplifier Unit 2 to the car.
CQ-DVR909U
E
N
G
L
I
S
H
38
57