Location Of Controls - Panasonic PV-D4733S-K Operating Instructions Manual

Location of Controls (continued)
Rear View of DECK
AC Power Plug
• While plugged into an AC outlet,
this DECK consumes 4 W of
electrical power in off mode.
Component Video Output
Connector (Y, P , P
B
p. 13
Optical Digital Audio
Output Connector
(DVD Only)
p. 15
The following table shows the status of the output jacks when in VCR or DVD mode.
Video Output
Audio Out 1
Audio Out 2
VCR
DVD
• PROG functions on the remote are not available when using Component Video Output
Note
and S-VIDEO OUT. Please set TV to either RF INPUT or VIDEO INPUT, and then press
PROG.
To enjoy PROGRESSIVE SCAN video
(1). Connect Component Video Output to the component video input terminals of a television.
(See p. 13.)
(2). When the PROGRESSIVE button is pressed, the ON lamp lights up (see p. 9) and the
PROGRESSIVE SCAN signal is output from the Component Video Output Connector .
Notes
• The PROGRESSIVE button can be operated when the DECK is in DVD function mode.
• The screen may shift off-center when using progressive output. Please adjust the screen
position if this occurs. (Refer to your TV manual.)
• The DECK outputs video signals (not PROGRESSIVE SCAN) from the "VIDEO OUT" and
"S-VIDEO OUT" terminals when the ON lamp is lit.
10
PV-D4733S-K(E) P1-25 (030314).p65
Bold: VCR Function
Bold Italic : VCR and DVD Functions
VHF/UHF Antenna Output Terminal
p. 12
VHF/UHF Antenna Input Terminal
p. 12
) (DVD Only)
R
Video Output
Connector
p. 12
S-Video Out
Audio Output 2
Connector
Connector (L/R)
(DVD Only)
p. 13
pp. 10, 13
Audio Output 1
Connector (L/R)
p. 12
Component
Video Output
YES N/A
YES
10
Italic : DVD Function
Video Input
Connector
p. 35
• •
Audio Input
Connector (L/R)
p. 35
S-VIDEO OUT
N/A
YES
2003/04/09, 13:52