Inter-m AOE-212N Operation Manual page 11

3. Audio Setup
Content
Mode Setup the audio transmission mode.
Audio Client Setup to receive the audio from another AOE-212N.
Port Setup the connecting port value to receive the audio.
IP Address Setup the IP address to receive the server address audio.
Buffer rate The buffer rate is set according to the receiver's network.
Run Check to activate audio receiving.
Audio sever Transmitting audio to other AOE-212N.
Sampling Rate Set the sample rate of the audio signal.
INPUT CH 1 is selected; the sender channel 1 is
transmitted to the receiver AOE-212N and
is outputted on the receiver's CH1 audio output.
Channels
INPUT CH 2 is selected; the sender channel 2
is transmitted to the receiver AOE-212N and is
outputted on the receiver's CH2 audio output.ㅍ
Setup the connecting port value to transmit
Port
the port audio.
Set the server address for Multi-cast audio
Sever Address
transmission mode.
Sets'Run'to begin audio transmission.
Run The equipment list of equipment being sent to the
serial communication serial server run-time will be displayed.
Apply and save the changed contents by using the
Set
Clear Restore all setups to default values by using
Default
button after changing the setup of SET device.
AUDIO OVER ETHERNET
Value
PCM, uni-cast
5454
192.168.1.99
3%
44100
1
5454
224.124.0.1
button.
AOE-212N
9