Coolant Level - PEUGEOT 5008 Handbook

Checks

Coolant level

The coolant level should be close
to the "MAX" mark but should never
exceed it.
When the engine is warm, the
temperature of the coolant is regulated by
the fan.
The cooling fan may start after switching
off the engine: take care with articles and
clothing that might become caught by the
fan blades.
In addition, as the cooling system is pressurised,
wait at least one hour after switching off the
engine before carrying out any work.
To avoid any risk of scalding, unscrew the cap
by two turns to allow the pressure to drop. When
the pressure has dropped, remove the cap and
top up the level.
Fluid specification
The coolant must conform to the
manufacturer's recommendations.
204
Screenwash and headlamp
wash fluid
In the case of vehicles fitted with
headlamp washers, the low fluid level
is indicated by an audible signal and
a message in the instrument panel
screen.
Top up the reservoir when you next stop the
vehicle.
Fluid specification
For optimum cleaning and to avoid freezing,
this fluid must not be topped up with or
replaced with plain water.
In wintry conditions, the use of an
ethyl alcohol or methanol base fluid is
recommended.
Diesel additive level
(Diesel engine with particle
emission filter)
A low additive level is indicated by
illumination of the service warning
lamp, accompanied by an audible
warning and a message in the instrument panel
screen.
Topping up
This additive must be topped up by a
PEUGEOT dealer or a qualified workshop
without delay.
Used products
Avoid prolonged contact of used oil or
fluids with the skin.
Most of these fluids are harmful to
health or indeed very corrosive.
Do not discard used oil or fluids into
sewers or onto the ground.
Take used oil to a PEUGEOT dealer or
a qualified workshop (France) or to an
authorised waste disposal site.