Table of Contents
Advertisement
Quick Links
This book is valuable. In addition to instructing you on how to install and maintain your appliance, it also contains information that will
enable you to obtain replacement parts or optional accessory items when needed. Keep it with your other important papers.
WARNING:
ALWAYS
DOORS FULLY OPENED OR FULLY CLOSED
WHEN OPERATING THIS FIREPLACE.
This fireplace is approved for use as a wood burning fireplace or for use with a vented gas log approved to ANS Z21.60, Z21.84 or
RGA 2-72 standards or for use with a vent-free gas log heater approved to ANS Z21.11.2 standard. A vent-free log can only be
installed in an aftermarket (completion of sale, not for purpose of resale from the manufacturer), permanently located, manufactured
(mobile) home, where not prohibited by local codes. A DESA hood must be installed when using a vent-free gas log heater (see
Accessories, p. 10)
ALL DIMENSIONS IN THIS MANUAL ARE IN
INCHES UNLESS OTHERWISE SPECIFIED
DESA INTERNATIONAL
2701 INDUSTRIAL DRIVE
P.O. BOX 90024
BOWLING GREEN, KY 42102-9004
www.desatech.com
Models: 36 LM Left Side Opening / 36RM Right Side Opening
Includes: Manual Variable Control Fan System, Combustion
INSTALLATION INSTRUCTIONS
SAVE THIS BOOK
LEAVE
GLASS
This firebox meets the construction and safety standards of H.U.D. for
application in mobile homes when installed according to these instructions.
36" Open Corner Circulating (louvered)
Wood Burning Fireplace
Air Kit and Bi-Fold Doors with Brushed Brass finish
PN 56095
REV B
6/00
Advertisement
Table of Contents
Related Manuals for Coleman 36 LM
Summary of Contents for Coleman 36 LM
-
Page 1: Installation Instructions
36” Open Corner Circulating (louvered) Wood Burning Fireplace Models: 36 LM Left Side Opening / 36RM Right Side Opening Includes: Manual Variable Control Fan System, Combustion Air Kit and Bi-Fold Doors with Brushed Brass finish INSTALLATION INSTRUCTIONS SAVE THIS BOOK This book is valuable. -
Page 2: Table Of Contents
CONTENTS INTRODUCTION --------------------------------------------------------------------------------- PG. 2 SELECTING LOCATION --------------------------------------------------------------------------------- PG. 2 3. MINIMUM CLEARANCES --------------------------------------------------------------------------------- PG. 2 4. FRAMING AND INSTALLING --------------------------------------------------------------------------------- PG. 3 5. HEARTH EXTENSION --------------------------------------------------------------------------------- PG. 3 6. OUTSIDE AIR KIT INSTALLATION --------------------------------------------------------------------------------- PG. 4 7. FAN KIT ASSEMBLY --------------------------------------------------------------------------------- PG. -
Page 3: Introduction
WARNING: DO NOT INSTALL A FIREPLACE INSERT FOR YOUR SAFETY IN THIS BOX UNLESS THE MANUFACTURER’S • INSTRUCTIONS WITH THE INSERT SPECIFICALLY Do not store or use gasoline or any other flammable STATE THIS FIREPLACE HAS BEEN TESTED FOR vapors or liquids in the vicinity of this or any other USE WITH THE INSERT. -
Page 4: Framing And Installing
FRAMING AND INSTALLING THE FIREPLACE HEARTH EXTENSION: STEP 1: Frame the opening for the fireplace using the A hearth extension projecting a minimum of 16” in front of dimensions shown in figure 1 or 2. and a minimum of 8” beyond each side of the fireplace STEP 2: If the fireplace is to be installed directly on carpeting, opening is required to protect combustible floor construction tile (other than ceramic), or any combustible material other... -
Page 5: Outside Air Kit Installation
POUTSIDE AIR KIT (MODEL AK-6) The installation of an outside air kit should be installed during the rough framing of the fireplace due to the nature of its location. Outside combustion air is accessed through the mobile home floor (Refer to AK-6 Installation Instructions for details). - Page 6 ADJUSTABLE FIRESTOP THIMBLE (FST-A): If the adapter is needed, secure it onto the firestop using holes The Adjustable Firestop Thimble Assembly (FST-A) is used provided (see figure 10). The row of holes on the sides of the to provide the necessary air space and clearance between the thimble is provided to allow for pitch variances.
-
Page 7: Terminations
FLASHING INSTALLATION: (6F-8 or 12F-8) IMPORTANT: Terminations are required but can be installed Determine the flashing to be used with the roof-opening chart. once the manufactured house is sited. Slide flashing over pipe until base is flat against roof. Replace as many shingles as needed to cover exposed area and flashing base. -
Page 8: Finishing Your Fireplace
10 FOOT RULE: Mantels or any other combustible materials such as wallboard, All flue gas outlet of chimney termination must extend a sheet rock, drywall, plywood, etc. butt up to the side of the minimum of 3 feet in height above the highest point where it black metal face of the fireplace. -
Page 9: Gas Line Installations
IMPORTANT: The glass must be allowed to warm slowly and evenly. The tempered glass will withstand a gradual temperature rise to 550 degrees Fahrenheit, which is more than a normal fire will generate. Such materials as pitch/wax- laden logs, very dry mill end lumber, and large amounts of paper or cardboard boxes can create an excessively hot fire and should not be burned in this fireplace. -
Page 10: Firestop Spacer
If you install a decorative gas appliance (vented gas log), the DAMPER OPERATION: decorative gas appliance must comply with the Standard for The damper handle to open and close the damper blade is Decorative Gas Appliances for Installation in solid fuel located inside the firebox at the center towards the back wall. -
Page 11: Replacement And Technical Parts
REPLACEMENT PARTS ACCESSORY PARTS VENT KIT PART NUMBERS SEE BELOW VENT KITS - USE FOR MOST COMMON MANUFACTURED (MOBILE) HOME INSTALLATIONS CONTENTS CPMH-A/AC CPMH-ACA CPMH-A/ACB 8' vent kit 9' vent kit 9' vent kit 36-8DM 36" Double Wall Pipe 24-8DM 24" Double Wall Pipe 18-8DM 18"... - Page 12 REPLACEMENT PARTS ACCESSORY PARTS VENT KIT PART NUMBERS SEE BELOW VENT KITS - USE FOR MOST COMMON MANUFACTURED (MOBILE) HOME INSTALLATIONS CONTENTS CPMH-A/AC CPMH-ACA CPMH-A/ACB 8' vent kit 9' vent kit 9' vent kit 36-8DM 36" Double Wall Pipe 24-8DM 24" Double Wall Pipe 18-8DM 18"...
- Page 13 P/N 035-16687-000...
Need help?
Do you have a question about the 36 LM and is the answer not in the manual?
Questions and answers