Toshiba 55L7400 User Manual page 6

Integrated high definition led television
Table of Contents

Advertisement

6
disconnect
the antenna from the TV if you leave
the TV unattended
or unused for long periods of
time.
41)Always
unplug the TV to completely
disconnect
from mains power. When the TV is turned off
using the on/off switch, it is not completely
disconnected
from power and a minute amount of
current is still consumed.
42) During normal use, the TV may make occasional
snapping
or popping sounds. This is normal,
especially
when the unit is being turned on or off.
If these sounds become frequent or continuous,
unplug the power cord and contact a Toshiba
Authorized
Service Provider.
43)
WARNING:
RiSK OF SERIOUS
PERSONAL
INJURY OR EQUIPMENT
DAMAGE!
Never strike the screen with a sharp or heavy
object.
44).
The LCD screen of this product can be damaged
by ultraviolet
radiation from the sun. When
selecting a location for the television,
avoid
locations where the screen may be exposed to
direct sunlight, such as in front of a window.
* Never touch, press, or place anything
on the
LCD screen. These actions witl damage the
LCD screen. If you need to clean the LCD
screen follow the instructions
in item 36) on
page 5.
Service
45)
WARNING:
RISK OF ELECTRIC SHOCK!
Never attempt to service the TV yourself.
Opening
and removing
the covers may expose you to
dangerous
voltage or other hazards. Failure
to follow this WARNING may result in death or
serious injury. Refer atl servicing not specified
in this manual to a Toshiba Authorized
Service
Provider.
46) If you have the TV serviced:
* Ask the service technician
to use only
replacement
parts specified by the manufacturer.
* Upon completion of service, ask the service
technician to perform routine safety checks
to determine
that the TV is in safe operating
condition.
Choosinga location for your LEDTV
To Display
your LED TV on the included
Pedestal
Stand:
Observe the following safety precautions:
1) Read and follow the pedestal stand assembly
instructions included with the pedestal.
CAUTmON: Before beginning pedestal
assembly,
carefully lay the front of the LCD Panel face down
on a flat, cushioned
surface such as a quilt or
blanket. Leave the bottom of the unit protruding
over the edge of the surface and assemble
the
pedestal as in the Quick Start Guide.
Note: Extreme care should always be used when
attaching the pedestal stand to avoid damage to
the L CD panel.
2) Place the TV on a sturdy, level surface that can
support the weight of the TV.
3) Be sure to secure the TV to a walt, pillar, surface,
or other immovable
structure see item 26) on
page 4 for additional details.
ToDisplay yourLED TVusing a WallBracket:
If you decide to wall mount your LED TV, always use
a watl bracket Listed by an independent
laboratory
(such as UL, CSA, ETL) that is appropriate
for the
size and weight of the TV:
1) CAUTION:
Two or more people are required for
installation.
2) Unplug and remove any cables and/or other
component
connectors from the rear of the TV.
3) Remove the screws of the VESA Mounting
Pattern shown in the table, if applicable.
CAUTION:
Do not use the screws removed from
the back cover to attach the wall mount bracket to
the TV.
4)
Always use the screws supplied or recommended
by the wall mount manufacturer.
5) Follow the instructions
provided with your wall
bracket. Before proceeding,
make sure the
appropriate
bracket(s)
are attached to the wall and
the back of the TV as described in the instructions
provided with the walt bracket.
6) After attaching the appropriate
bracket(s)
to the
wall and the back of the TV, remove the pedestal
stand from the TV, as described in this instruction
document.
7) VESA Mounting
Pattern
Removing t he Pedestal S tand
1 ) Carefully
lay the front of the unit face down on a
flat, cushioned
surface such as a quilt or blanket.
Leave the stand protruding over the edge of the
surface.
Note: Extreme care should always be used when
removing
the pedestal
stand to avoid damage
to
the L CD panel.
2) Remove the stand screws shown in the diagram.
This will allow removal of the pedestal stand.
3) Once you have removed all screws holding the
pedestal stand in place, remove the pedestal
stand from the TV.

Advertisement

Table of Contents
loading

Table of Contents