Intelligent UFM-B Maintenance Manual page 14

2.4.10 Auto Tare Function Setting (F9)
a. Refer to the 2.4.1 on how to enter F9
b. Press MODE to select Troff or Tr_on
-Troff will disable the auto tare off function
-Tr_on will enable the auto tare function and tare off the first
weight that is placed on the scale
c. Press TARE to save and return to other functions
2.4.11 High Resolution Verification Mode (F19)
This function is intended to be used only by the manufacturer for initial
verification purpose.
2.4.12 Gravity Compensation Device – C.G. (F20)
This function stores the gravity value of where the scale is manufactured.
Scale was calibrated according to the value stored.
a. Refer to the 2.4.1 on how to enter F20
b. Use MODE to shift to next digit and use ON/ZERO to increase the
value
c. Press and hold MODE to save or TARE to quit
-When the
automatically to reflect the change in gravity. Please refer to
2.4.14 for how to calibrate the scale
2.4.13 Gravity Compensation Device – U.G. (F21)
This function stores the gravity value of where the scale will be used.
The value stored in F.21 will be used to compare with the value in
F.20 to compensate the difference in gravity value.
a. Refer to the 2.4.1 on how to enter F21
b. Use MODE to shift to next digit and use ON/ZERO to increase the
value
c. Press and hold MODE to save and return to other functions
change is saved, scale will enter calibration
13