Electrical Adjustments; Power Supply Adjustment; Power Supply Check (Hs-030Sf/030Sh Board, Srv902Uc Board) - Sony DVP-S530D Service Manual

In making adjustment, refer to 7-3. Adjustment
Related Parts Arrangement.
Note: During diagnostic check, the characters and color bars can
be seen only with the NTSC monitor. Therefore, for diag-
nostic check, use the monitor that supports both NTSC and
PAL modes
This section describes procedures and instructions necessary for
adjusting electrical circuits in this set.
Instruments required:
1) Color monitor TV
2) Oscilloscope 1 or 2 phenomena, band width over 100 MHz,
with delay mode
3) Frequency counter (over 8 digits)
4) Digital voltmeter
5) Standard commander
(RMT-D108A/D109A/D111A/D111E)
6) DVD reference disc
HLX-501 (J-6090-071-A) (dual layer)
HLX-503 (J-6090-069-A) (single layer)
HLX-504 (J-6090-088-A) (single layer)
HLX-505 (J-6090-089-A) (dual layer)
7) SACD reference disc
HLXA-509 (J-6090-090-A)
SECTION 7

ELECTRICAL ADJUSTMENTS

7-1. POWER SUPPLY ADJUSTMENT

1. Power Supply Check
Checking method:
1) Confirm that each voltage satisfies the specification.
2. +3.3 V Adjustment (SRV902UC BOARD)
7-1
DVP-S330/S530D/S550D/S705D
(HS-030SF/030SH BOARD, SRV902UC BOARD)
Mode E-E
Instrument Digital voltmeter
+5 V Check
CN202 pin 5
Test point
Specification 5.0 ± 0.2 Vdc
+3.3 V Check
CN202 pin 7
Test point
Specification 3.3 ± 0.2 Vdc
EVER+5 V Check
CN203 pin 2
Test point
Specification 5.0 ± 0.2 Vdc
P_CONT Check
CN203 pin 1
Test point
Specification 4V – 5 Vdc
A +12 V Check
CN202 pin 1
Test point
Specification 9.5
–12 V Check
CN203 pin 5
Test point
Specification –12.0 ± 1.0 Vdc
M +12 V Check
CN202 pin 2
Test point
Specification 12.0 ± 1.0 Vdc
(DVP-S330/S530D: US, Canadian/S550D)
Mode PB
Measuring Instrument Digital voltmeter
CN202 pin 7
Measurement Point
Adjusting Element VR201
Specified Value 3.3 ± 0.2 V
+1.5
Vdc
–0.5