Bosch Carephone 50 ISA-50-MS User And Programming Manua page 29

Carephone 50
11 - 19 Phone number of the emergency call recipient
1.
2.
3.
The HTS switches automatically to programming step 12 and you
can enter the next number.
NOTE! When an emergency call is made, if the call to the first
call number is unsuccessful, the HTS will try the other numbers
in the sequence 2 to 10. If the last number has been dialled
unsuccessfully, the unit starts with the first number again and
continues until it either sends an emergency call successfully or
all of the programmed numbers have been tried 15 times.
B= Dial pause
D= Dial tone detection
#= Flash (see Section 18.2 Programming Tables, Page 42,
Programming step 21)
Example: HTS50 on an exchange line
Call number:
1.
2.
3.
After entering the call number, you enter the call destination,
e.g. the social alarm call centre. You program:
NOTE! After programming step 19 the HTS goes to programming
step 10.
Bosch Security Systems
Select programming step 11.
Enter the phone number of the emergency call recipient.
Press C to confirm.
Call number of the emergency call recipient
Area code
Dial tone detection
0 = social alarm call centre (Bosch protocol)
4 = to phone
User Manual
Programming | en 29
ISA-50-MS V2 I 2008.02