Table of Contents
Advertisement
Carephone 50
12.5
Programming Procedure
To program the HTS50 on the unit itself,
1.
2.
3.
4.
5.
6.
7.
Bosch Security Systems
Remove the cover from the HTS.
Press P to go to the programming mode. The HTS
announces Set-up.
Enter the PIN. The PIN factory setting is 246810. If the PIN
is entered correctly, the unit announces Selection.
On the programming keypad, enter the programming step
whose setting you wish to change. The programming steps
can be carried out in any order.
Enter the new setting as required.
Press the C key to confirm your entries. The HTS
automatically goes to the next programming step.
To leave the programming mode,
Press the * key twice.
User Manual
Programming | en 27
ISA-50-MS V2 I 2008.02
Advertisement
Table of Contents
