Panasonic KX-TS500EX Operating Instructions

E-SP-PQQX13904ZA 03.8.20 6:47 PM ページ 1
1

Getting Started

1-A Location of controls
Integrated Telephone System
Operating Instructions
KX-TS500EX
Model No.
RINGER Selector
(1-B)
KX-TS500EXW
Accessories (included)
∑ Handset. . . . . . . one
PLEASE READ BEFORE USE AND SAVE.
∑ Handset Cord. . . one
4 Things You Should Know
For your future reference
4-A Wall Mounting
Serial No.
(found on the bottom of the unit)
The unit can be mounted on a wall.
Date of purchase
1
Press the tabs in the direction of the arrows
(1), then remove the wall mounting adaptor
Name and address of dealer
(2).
If trouble occurs, disconnect the unit from the
telephone line and connect to a known working 1
phone. If the known working phone operates
properly, do not reconnect the unit until the trouble
2
Tuck the telephone line cord inside the wall
has been repaired. If the known working phone
mounting adaptor, and push it in the
does not operate properly, consult your telephone
direction of the arrow (1 and 2).
company.
≥The word "UP WALL" should face upward.
Manufactured by Panasonic
Communications (Malaysia) Sdn. Bhd.
Senai Malaysia
PQQX13904ZA F0803-0 D
1-B Settings
1
Connect the telephone line cord (1).
2
VOLUME (^), (_)
Connect the handset cord (2), then confirm
Buttons (2-A)
the dial tone.
≥Use only a telephone line cord included in the
unit.
To Single-Line Telephone Jack
Telephone Line Cord
1
(R) Button (3-A)
Button (2-A)
∑ Telephone Line Cord
Handset Cord
. . . . . . . . . . . . . one
3
Install screws using the wall template
below. Connect the telephone line cord.
Mount the unit, then slide down.
≥Fasten the cord to prevent it from being
disconnected.
2
1
Hooks
2
Wall Template
1
8.3 cm
3
Set the RINGER selector to HIGH, LOW or
OFF.
(Ex. "LOW" is selected.)
RINGER
HIGH OFF
≥ When set to OFF, the unit will not ring.
RINGER Selector
2
Handset
To temporarily set the
handset down during
a conversation, place
it as shown here.
Screws
4-B Troubleshooting
Problem Remedy
8.3 cm
The unit does not ≥Check the settings (1-B).
work.
The call cannot be ≥Check the settings (1-B).
connected even if
To Single-Line
you dialed
Telephone Jack
correctly.
The unit does not ≥The RINGER selector is
ring. set to OFF. Set to HIGH
or LOW (1-B).
2 Operation 3

Special Features

2-A Making Calls 3-A For Call Waiting Service Users
1 (R)
Press if you hear a call-waiting tone while
Lift the handset.
talking.
2
Dial a phone number.
≥The first call is put on hold and you can answer the
≥If you misdial, hang up and start again from
second call.
step 1.
≥To return to the first caller, press (R) again.
3
When finished talking, hang up.
To redial the last number dialed
Lift the handset. ➡ Press (\\\)
.
To adjust the receiver volume (6 levels)
while talking
To increase, press (^).
To decrease, press (_).
≥ After hanging up, the volume level will be saved.
2-B Answering Calls
1
When the unit rings, lift the handset.
2
When finished talking, hang up.
4-C Safety Instructions 4-D Specifications
Power Source:
Take special care to follow the safety suggestions
Dimensions (H x W x D):
listed below.
Installations
Mass (Weight):
Environment Dialing Mode:
Operating Environment:
1) Do not use this unit near water—for example,
near a bathtub, washbowl, sink, etc. Damp
Specifications are subject to change without notice.
basements should also be avoided.
2) The unit should be kept away from heat sources
such as radiators, kitchen range, etc. It also
should not be placed in rooms where the
temperature is less than 5oC or greater than 40oC.
1999/5/EC
This equipment is designed for use in Italy, Spain,
Placement
Greece, Netherlands and France.
1) Do not place heavy objects on top of this unit.
2) Care should be taken so that objects do not fall
In the event of problems, you should contact your
onto, and liquids are not spilled into the unit. Do equipment supplier in the first instance.
not subject this unit to excessive smoke, dust,
We, Panasonic Communications Co., Ltd. declare
mechanical vibration or shock.
that this equipment is in compliance with the
3) Place the unit on a flat surface.
essential requirements and other relevant provisions
of Directive 1999/5/EC.
WARNING:
TO PREVENT FIRE OR SHOCK HAZARD, DO If you want to get a copy of the original Declaration
NOT EXPOSE THIS PRODUCT TO RAIN OR ANY of Conformity of our products which relates to the
R&TTE, please contact to our web address:
TYPE OF MOISTURE.
http://doc.panasonic-tc.de
From telephone line
Approx. 96 mm x 150 mm x 200 mm
Approx. 475 g
Tone (DTMF)
5°C–40°C