Pro-Form 700 ZLT PETL80910.0 User Manual page 13

16. Make sure that all parts are properly tightened before you use the treadmill. If there are sheets of plastic
on the treadmill decals, remove the plastic. To protect the floor or carpet, place a mat under the treadmill.
Note: Extra hardware may be included. Keep the included hex keys in a secure place; one of the hex keys is
used to adjust the walking belt (see pages 23 and 24).
If you purchase the optional chest pulse sensor (see page 20), follow the steps below to install the re-
ceiver included with the chest pulse sensor.
1. Make sure that the power cord is unplugged.
Remove the eleven #8 x 3/4" Screws (1) and the
four #8 x 1/2" Screws (16) from the back of the
Console Base (106).
2. Carefully lift the console assembly off the
Console Base (106). Be careful not to pull on
the console wire (A). Locate the Short Wire (B)
on the back of console assembly. Connect the
wire on the Receiver (C) to the Short Wire.
See the inset drawing. Peel the paper backing
off the pad on the bottom of the Receiver (C).
Next, hold the Receiver so that the antenna
is oriented as shown.
Press the Receiver (C) onto the back of the con-
sole assembly in the location shown.
3. See step 1. Reattach the console assembly.
Make sure that no wires are pinched. Discard
the other wires included with the receiver.
1
16
1
2
Console Assembly
A
106
Antenna
C
13
106
1
16
1
16
1
1
1
B
C
Pad
B