Pro-Form 700 ZLT PETL80910.0 User Manual page 10

8. Identify the Left Base Cover (88) and the Right
Base Cover (91). Slide the Left Base Cover onto
the Left Upright (84) and the Right Base Cover
onto the Right Upright (85).
9. Slide the Right Upright Cover (86) onto the
Right Upright (85).
Remove the tie from the bracket on the Right
Handrail (83). If necessary, press the 5/16"
Cage Nut (38) back into place.
Hold the Right Handrail (83) near the Right
Upright (85). Insert the Upright Wire (87)
through the bracket on the bottom of the Right
Handrail and out of the end of the Right
Handrail.
Attach the Right Handrail (83) to the Right
Upright (85) with two 5/16" x 1" Flat Head Patch
Bolts (14), a 5/16" x 1" Patch Bolt (4), and a
5/16" Star Washer (13) as shown. Do not
tighten the Patch Bolts yet.
Repeat this step on the left side of the treadmill.
Note: There is not a wire in the Left Upright.
10. Set the console assembly face down on a soft
surface to avoid scratching the console assem-
bly. Remove the two #8 x 3/4" Screws (1). Lift
off the Crossbar (107).
8
84
88
9
87
Bracket
14
83
10
1
Console
Assembly
10
85
91
38
4
13
86
85
107