SAGEMCOM C112 ECO User Manual page 34

The phone does not ring when
a call is received.
Your correspondent cannot
hear you.
You obtain a "busy" dial tone
for each dialled number.
The new event
indicator continues
to wink after all the voice
messages have been read.
There is no ring tone volume
(set to OFF).
You have turned on the mute mode
(microphone off).
Check that the message "Mute" is
not displayed.
Incorrect flashing time.
Notification that voice messages
have been read may not reach the
telephone because of a network
error.
Increase the ring tone volume (Refer to paragraph
"Adjusting the volume of the ring tone
Turn off the mute mode (microphone cut off) by pressing the
key .
Set the flashing time (Refer to paragraph
flash duration (Key «R») ", page 26).
Contact your operator to get correct flashing time.
Switch off the indicator manually using the menu
LED" (Refer to paragraph
page 28).
", page 25).
"Modifying the
"Switch off
"Switching off the LED ",
33