Table of Contents
Advertisement
Switches for Trend Sampling
When displaying sampled data, scrolling, resetting, etc. can be performed by
setting a switch.
♦
Notes on Setting
[Division No.]
[Function]
Roll Up
Roll Down
Plus Block
Minus Block
Graph Return
Reset
Specify the division number. Specify the same division number as the trend
sampling part. (
For information on the division number, refer to
Chapter 2 in the Reference Manual (Operation).)
Set the switch function. The following switch functions are available with
trend sampling.
Function
Scrolls by one data element toward the most recent entry. If all data
cannot be held in the graph, one data element at a time scrolls into
view.
Scrolls by one data element toward the oldest entry. If all data cannot
be held in the graph, one data element at a time scrolls into view.
Scrolls by one page toward the most recent entry.
Scrolls by one page toward the oldest entry.
Returns to the most recent graph display when it is pressed while
flashing. Flashing is canceled as well as the selection.
When the switch is pressed once, it is turned on. Pressing it again
within 2 seconds clears the buffering area. Sampling restarts
immediately after clearing. If not pressed again within 2 seconds, the
switch is turned off, and resetting is nullified.
Chapter 10 Sampling
Contents
10
10-29
Advertisement
Table of Contents
