Stapling; Hole Punching - Konica Minolta bizhub C252 User Manual

Setting Up the PCL Driver

Stapling

Multiple-page documents can be stapled.
The staple function is available only when the optional finisher is installed.
1
Click the Setup tab.
2
Select the "Staple" check box.
3
From the drop-down list, specify the number of staples and the sta-
pling position.
Note
Depending on the selected Binding Position setting, different stapling po-
sitions are available.
The number of staples that can be selected may vary depending on the
finisher that is installed. When optional finisher FS-501 is installed, spec-
ify "1 staple". When optional finisher FS-514 or FS-603 is installed, spec-
ify "1 staple" or "2 staples".

Hole Punching

Holes can be punched into the printed document.
The hole punch function is available only when optional finisher FS-514 and
punch kit PK-510 are installed, or when optional finisher FS-603 and punch
kit PK-501 are installed.
1
Click the Setup tab.
2
Select the "Hole-Punch" check box.
3
From the drop-down list, specify the number of punched holes.
C252
5
5-11