KLING & FREITAG LINE 212-6-SP User Manual page 33

Table of Contents

Advertisement

User's Manual
15.2 LINE 212-9 - SP
Loudspeaker
Loudspeaker
Loudspeaker
Loudspeaker
Input module
Input module
Input module
Input module
Amplifier module (2 x)
Amplifier module (2 x)
Amplifier module (2 x)
Amplifier module (2 x)
Enclosure
Enclos
Enclos
Enclos
Technical changes without prior notice reserved
KLING & FREITAG GMBH ©2003 - 2006
Design
Frequency range -10 dB
Frequency range ± 3 dB
Nominal coverage angle
Directivity index (DI)
Max. SPL
Components
Crossover
Supply voltage
alternative
Power consumption (nominal)
Max. Power consump. (Irms / <500 ms) @ 230 V: 8 A
Idle current
Power connectors
Signal connectors
Input sensitivity
Input impedance
Common mode rejection
Controls
Display
Driver circuit
Type
Power
Power bandwidth
Damping factor
S / N ratio
Cooling
Protection circuits
ure
ure
ure
Rigging
Dimensions
Weight
Options
2+1-way full-range system with integrated driver and
power amplifier technology,
completely horn loaded, bass reflex tuning
51 Hz - 20 kHz ('FILTERS ON'), 65 Hz - 20 kHz ('FILTERS OFF')
49 Hz - 20 kHz ('FILTERS OFF' with C2 Controller)
66 Hz - 18 kHz ('FILTERS ON'), 130 Hz - 18 kHz ('FILTERS OFF')
60 Hz - 18 kHz ('FILTERS OFF' with C2 Controller)
90° x 50° / rotatable horn
10 (±1.5) 600 Hz - 12 kHz
135 dB (SPL peak/1 m)
1 x 12'' woofer and 1 x 12'' low-mid chassis with horns,
1.5'' high freq. driver with 75 mm titanium dome on
rotatable CD horn
Active (1) and passive (2) in FLC technology, delay time
correction and phase optimisation, self-resetting
protection circuit for 1.5'' driver
AC 195-250 V, 50 / 60 Hz (230 V version)
AC 95-125 V, 50 / 60 Hz (115 V version)
@ 230 V: 1.25 A
@ 230 V: 360mA
Neutrik PowerCon, lockable, 1 input and 1 output
Pin 1 = ground / pin 2 = + signal / pin 3 = - signal
LINE IN: XLR 3 pin female
LINE OUT: XLR 3 pin male, parallel with LINE IN
+6 dB / 1.55 Vrms for rated output
50 kW (balanced / unbalanced)
Min.: 74 dB, typical: 90 dB
Level control ± 6 dB, bypass switch for the
active filters (for operations with external controller),
ground lift switch
Bi-coloured LED: green = Power On,
red = Limit / Protect
Peak limiter, RMS limiter
High-pass 45 Hz (-3 dB), 24 dB / octave ('FILTERS ON'),
Phase correction, frequency equalisation (EQ)
Class D
1000 W @ 8 Ω ( EIAJ / 1 kHz, 1% THD)
10 Hz to 30 kHz
> 500 (100 Hz), > 100 (10 kHz)
> 105 dB (A)
Air convection (without fan)
Short circuit, over-temperature, clipping, overload
Trapezoidal, frame-reinforced 15 mm birch plywood with
with highly resistable grey or black structured paint,
2 butterfly handles, ball proof front grille with
exchangeable black acoustic foam
4 flying points 'allsafe JUNGFALK'
1 rear mounted flying track 'allsafe JUNGFALK'
429 x 1025 x 510 mm (W x H x D)
57.5 kg
special finish in RAL colours
Version 4.1, 19.06.2006
LINE 212-6 - SP / LINE 212-9 - SP
@ 115 V: 2.5 A
@ 115 V: 16 A
@ 115 V: 720 mA
Page 33 of 45

Advertisement

Table of Contents
loading

This manual is also suitable for:

Line 212-9-sp

Table of Contents