Advertisement
Adjusting angle of tool base
Loosen the wing bolts and adjust the angle
of the tool base (5' per graduation) to
obtain the desired cutting angle.
-
Gradual
Wing n u t
__
Wing b o l t
~ _ _ _
Base
It
of
ring
Adjusting amount of chamfering
To adjust the amount of chamfering, loosen the wing nuts and adjust the trimmer shoe.
CAUTION
:
With the tool unplugged and switch in the "OFF" position, rotate the collet nut on the
tool several times to be sure that the bit turns freely and does not contact the tool base
or trimmer shoe in any way.
Switch action
To start the tool, move the switch lever
to the "ON" position. To stop, move the
switch lever to the "OFF" position.
Operation
Turn the tool on without the bit making
any contact with the workpiece and wait
until the bit attains full speed. Then move
the tool over the workpiece surface, keep-
ing the tool base and trimmer shoe flush
with the sides of the workpiece.
6
Advertisement
