Led Messages; Image Problems - Canon LV-WX300UST User Manual

LED Messages

E C
RROR
Power On
Power Off
Cooling
Over Temperature
Thermal Break Sensor error
Lamp error
Fan 1
Fan 2
Fan 3
Fan 4
Lamp Door Open
DMD error
Color wheel error
In the event of an error, please disconnect the AC power cord and wait for one (1) minute before
restarting the projector. If the Power or Lamp LEDs are still blinking or any other situation that isn't listed
in the chart above , please contact your service center.

Image Problems

Problem: No image appears on the screen
1. Verify the settings on your notebook or desktop PC.
2. Turn off all equipment and power up again in the correct order.
Problem: The image is blurred
1. Adjust the Focus on the projector.
2. Press the Auto button on the remote control.
3. Ensure the projector-to-screen distance is within the specified range.
4. Check that the projector lens is clean.
Problem: The image is wider at the top or bottom (keystone distortion)
1. Position the projector so it is as perpendicular to the screen as possible.
2. Use the Keystone button on the remote control to correct the problem.
Problem: The image is reversed
Check the Image Flip H/V setting on the Installation I menu of the OSD.
Problem: The image is streaked
1. Set the Frequency and Total Dots settings on the Computer menu of the OSD to the
default settings.
2. To ensure the problem is not caused by a connected PC's video card, connect to
another computer.
Problem: The image is flat with no contrast
Adjust the Contrast setting on the Image menu of the OSD.
Problem: The color of the projected image does not match the source image.
1. Adjust the Gamma settings on the Image menu of the OSD.
M
ODE ESSAGES
P L
OWER ED
G
REEN
ON
ON
Flashing
OFF
4 blinks
OFF
6 blinks
6 blinks
6 blinks
6 blinks
7 blinks
8 blinks
9 blinks
— 58—
L L T
AMP ED EMP
A
MBER
OFF
OFF
OFF
OFF
OFF
ON
1 blinks
2 blinks
3 blinks
4 blinks
OFF
OFF
OFF
L
ED
R
ED
OFF
OFF
OFF
ON
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF