Sea Eagle SE-9 Instruction & Owner's Manual page 6

WARNING: Always connect the red clip to the positive pole
and the black clip to the negative pole. Cross connecting
wires could damage both the pump and boat.
MB-80 Electric Pump
(OPTIONAL)
The MB-80 electric
pump inflates the SE-9
in a matter of minutes.
This electric pump
works using the 12V
power outlet in your car
or with the optional,
Minn Kota Power Cen-
ter accessory.
First, check that the
pump is switched OFF
before inserting the
power adapter into your
car's power outlet.
_STOP
Directly insert the pump
(nozzle) into the valve
fill port. Please note the
valve adapters and
black tube that come
with the MB-80 are not
necessary for Sea
Eagle Boats.
Battery Connector
(OPTIONAL)
You can also power
your MB-80 using the
optional battery con-
nector which will allow
you to use the pump
while connected di-
rectly to a 12V car or
marine battery.
SeaEagle.com/Instructions
SeaEagle.com/Instructions
5
Assembly
Lay the boat out on a
flat area free of haz-
ards. If the package
you purchased includes
only seats and no
motor mount, follow
only the steps below
that apply.
If not installed already,
insert the inflatable
floor with the valve fac-
ing up and the edges
tucked under the sides.
Motor Mount Set
(OPTIONAL)
If you have the motor
mount set, layout the
items as shown here.
This set consists of
two rods with retainer
pins, motor mount
block and mounting
hardware.
Insert the motor mount
bar through the grom-
mets on top of the boat
and through the grom-
met on the bottom. Se-
cure the bottom with
the buttons. Repeat
with the other rod.