Completing Grate Set-Up; Checking Pilot Plate - Heat & Glo 8000TRLP-OAKIPI Owner's Manual

4. Center the Flue Restrictor on vent and secure in place
by using two self-tapping screws (see Figure 7.15).
Figure 7.15
E. Completing Grate Set-up
1. Straighten the tabs on the grate bracket (see Figure
7.16) and remove grate from unit.
2. Remove grate bracket (see Figure 7.16) by bending it
back and forth until it breaks. Discard grate bracket.
3. Remove 4 tabs holding base refractory (see Figure 7.16)
by bending tabs back and forth until they break.
4. Reinstall grate into unit (see Figure 7.17).
REMOVE GRATE
REMOVE GRATE BRACKET
REMOVE TAB HOLDING DOWN
BASE REFRACTORY (4 PLACES)
Figure 7.16 Removing Grate
Heat & Glo • 8000TR-OAK, 8000TR-OAK-IPI, 8000TRLP-OAKIPI • 2057-900 Rev. K • 12/07
1 2 3 4 5
SETTING
1 2 3 4 5
STRAIGHTEN TO
REMOVE GRATE
RE-INSTALL
INTO THE UNIT
Figure 7.17 Re-install grate in unit
F. Checking Pilot Plate
Note: Ensure pilot plate is in place. This will ensure pilot
stability (see Figure 7.18)
Figure 7.18
PILOT
PLATE
27