Chevrolet 2005 Impala Getting To Know Manual page 15

To program these features, follow these
procedures:
1. Turn the ignition to ACC or ON. The
radio must be off.
2. Press and hold the TUNE or DISP
button on the radio for at least
five seconds until SETTINGS is
displayed.
3. Press the SEEK/PSCAN up or down
arrow to scroll through each available
feature on your main menu.
4. Press the PREV or NEXT button to
scroll through the lower menu. An
asterisk (*) will appear next to the
item that is the current setting.
Transmitter Verification (Light)
This feature allows the exterior lights to
flash when the RKE transmitter is used
to lock or unlock the vehicle.
Programmable Modes
Mode 1: OFF — Turns feature off.
Mode 2: ON — One flash for each
remote lock/two flashes for each remote
unlock. (Your vehicle was programmed
to Mode 2 at the factory.)
To program the FOB LIGHT to a differ-
ent mode, do the following:
1. Scroll using the SEEK/PSCAN up or
down arrow, until FOB LIGHT
appears on the display.
2. Press the PREV or NEXT button to
enter the submenu. The current
selection will have an asterisk (*) next
to it.
3. Scroll, using the PREV or NEXT
button, through the modes to change
the current mode.
4. With your preference displayed, press
the TUNE/DISP button to select. A
chime will be heard to verify the new
setting.
The mode you selected is now set. You
can either exit the programming mode or
program the next feature available on
your vehicle.
Transmitter Verification (Horn)
This feature allows the horn to chirp
when the RKE transmitter is used to
lock or unlock the vehicle.
Programmable Modes
Mode 1: OFF — Turns feature off.
Mode 2: PARTIAL — One chirp for each
remote lock command/no chirp for
remote unlock command.
Mode 3: FULL — One chirp for each
remote lock command/two chirps for the
first remote unlock command. (Your
vehicle was programmed to Mode 1 at
the factory.)
To choose a different FOB HORN mode,
follow steps 1–4 (shown above) under
Transmitter Verification (Light).
See Section 2 of your Owner Manual.
15