Advertisement
8. Air Shutter-Broil
Burner
a.
Observe the flame to determine if the broiler burner flame is properly
adjusted.
It should be steady with approximately
1" blue cones and
no yellow or orange flame tips (See Figure 13).
b.
If adjustment
to the air shutter is necessary,
locate the broiler burner
air shutter (See figure 14), loosen shutter lock screw, and adjust to
obtain optimum flame. This will normally be completely
open for LP/
Propane gas. If the flame is yellow in color, increase the air shutter
opening size. If the flame is a distinct blue, but lifting away from the
burner, reduce the air shutter opening size. Tighten the shutter set
screw.
Glide
FIGURE
15
Lock Screw
Air Shutter
=_
Oven
Burner
Tube
Orifice
Hood
FIGURE
14
CONVERSION
TO NATURAL
GAS
If it becomes
necessary
to convert the range back to natural gas:
a.
Disconnect
gas and electrical
supply from range.
b.
Convert pressure regulator
(See step 1), turn cap over so the solid
end of cap faces outward.
Place the hollow end of the cap into the
loop end of the dust protector.
c.
Remove the four LP orifices using 7mm nutdriver
and replace with
the four original factory installed natural gas orifices at their original
locations
(See figure 4 for locations).
d.
Convert
Oven Burner Orifice for Natural
Gas by loosening
spud
counter-clockwise
(approximately
2-1/2 turns;
See step 3).
e.
Convert
Waist-High
Broiler
Burner Orifice
(Self-Cleaning
Models
Only)
for
Natural
Gas by loosening
spud
counter-clockwise
(approximately
2-1/2 turns).
(See step 4.)
f.
Readjust
"LOW"
Setting
for
Surface
Burner
Valves
following
instructions.
(See step 6.)
g.
Readjust
Oven & Broil Burner Air Shutters. (See steps 7 & 8.)
9. Replace Storage
Drawer or Warmer
Drawer
(instructions
for warmer drawer if equipped):
a.
Pull
the
bearing
glides
to the
front
of the chassis
glide
(See Figure 15).
b.
Align the glide on each side of the drawer with the glide slots on the
range.
c.
Push the drawer into the range until levers "click" (approximately
2").
Pull the drawer open again to seat bearing glides into position.
If you
do not hear the levers
"click"
or the bearing
glides
do not feel
seated
remove
the drawer
and repeat steps
"a" through
"c".
This will minimize
possible damage to the bearing glides.
10. Installation of New LP/Propane
Rating/Serial
Plate
Record the model and serial number on the LP/Propane
Rating/Serial plate
provided
in this kit. The information
can be obtained from the existing
Rating/Serial
plate. Place new plate as close as possible to the existing
Rating/Serial
plate on range (See the recommended
locations shown in
Figure
5).
Remove
Storage
Drawer
(some models),
L.P. Rating/Serial Plate
Pressure Regulator
location at rear of range
FIGURE
15
Advertisement
