Advertisement
Possible Surface Burner configurations
FRONT
4 NO COLOR ORIFICES
_1_
9.5k--_
_1
No Color
12k
A
O
Green_l_Q
FRONT
3 NO COLOR ORIFICES
1 GREEN ORIFICE
5k
O
Blue _O
9.5k No Color
FRONT
1 BLUE ORIFICE
2 NO COLOR ORIFICES
1 GREEN ORIFICE
_..12k Green
5k -----_O
"_"
Blue
9.5k No Color
•
FRONT
1 BLUE ORIFICE
1 NO COLOR ORIFICE
1 GREEN ORIFICE
1 RED ORIFICE
FIGURE
5
•
_-_
Surface
Burner
Orifice
Surface
Burner
Head
Removable
Burner
Drip Pan
(on some models)
FIGURE
6
2. Convert
Surface
Burners
for use with LP/
Propane Gas
[_[_J"_
Unlike the standard
gas range, THIS COOKTOP
IS
NOT REMOVABLE.
Do not attempt to remove this cooktop.
Save the natural gas orifices
removed from the appliance
for possible
future conversions
to natural
gas.
For all burner
locations:
a. Remove the top grate and burner cap (See Figure 6).
b. Use your hand to remove the burner head.
c. Remove the four factory installed natural gas orifices from the center
of the orifice holders using a 7 mm nutdriver (See Figure 7). Remember
to keep the original Natural Gas Orifices for later conversion to Natural
Gas. Refer to page 1 under "IMPORTANT"
to identify their markings.
d. Replace
the orifice
in each
of the four
orifice
holders
with the
correct
LP/Propane
gas orifice (refer to the LP Kit chart
listed
on
page
1; also
refer to Figures
4 and 5 for the correct
LP orifice
installation
at each of the four surface
burner
locations).
Tighten
each orifice until snug. Use caution
not to overtighten.
e. Replace the four burner heads (be sure burner head mates correctly
with each surface igniter) then replace the burner caps and grates.
_
Use caution when replacing
each burner cap so the
electrode
is not damaged.
Burner
Cap_
Inner
Locatinc
Ring
Burner
Head
7mm
Nut
Driver
Holder
D('oNot _{
}
Remove
Electrode
FIGURE
7
3. Convert Oven Burner Orifice for LP/Propane
Gas (16,000 BTU*)
a.
Locate the oven burner spud (See Figure 8).
b.
Using a 1/2" wrench, turn down the adjustable spud, which injects gas
into the oven burner, until snug against the LP/Propane
metering pin
(approximately
2-1/2 turns). Do not over
tighten.
4. Convert
Waist-High
Broiler
Burner
Orifice
Flame for LP/Propane
Gas (13,500 BTU*) mSelf-
Cleaning
Models
Only
a.
Open the oven door.
b.
Locate the broiler burner spud and turn down until snug against the
LP/Propane
metering pin (approximately
2-1/2 turns). Do not over
tighten
(See Figure 8).
5. Reconnect
Gas and Electrical
Supply
to
Range.
Leak testing
of the appliance
shall
be conducted
according
to the
Installation
Instructions
provided with the Range.
Advertisement
