Table of Contents
Advertisement
Programming
The reader is factory-configured with a set of standard
default features. After scanning the interface bar code
from the Interfaces section, select other options and
customize your reader through use of the programming bar
codes available in the DelfiScan C85 PRG. Check the
corresponding features section for your interface, and also
the Data Editing and Symbologies chapters of the PRG.
Using Programming Bar Codes
This manual contains bar codes which allow you to
reconfig-ure your reader. Some programming bar code
labels, like the "Reset Default Settings" on page 15, require
only the scan of that single label to enact the change.
Other bar codes require the reader to be placed in Program-
ming Mode prior to scanning them. Scan an ENTER/EXIT
bar code once to enter Programming Mode; scan the desired
parameter settings; scan the ENTER/EXIT bar code again to
accept your changes, which exits Programming Mode and
returns the reader to normal operation.
Configure Other Settings
Additional programming bar codes are available in the PRG
to allow for customizing programming features. If your
installa-tion requires different programming than the
standard fac-tory default settings, refer to the PRG.
Resetting Product Defaults
If you aren't sure what programming options are in your
reader, or you've changed some options and want your cus-
tom factory settings restored, scan the bar code below to
reset the reader to its initial configuration. Reference the
PRG for other options, and a listing of standard factory
settings.
Factory defaults are based on the interface
type. Be sure your reader is configured for the
correct interface before scanning this label.
See "Selecting the Interface Type" on page 4
for more information.
Quick Reference Guide
Reset Default Settings
Programming
15
Advertisement
Table of Contents
