Functional Description; Ground Fault Circuit Interrupter; Adjusting The Depth Of Cut; Bevel Cutting - Makita 4101RH Instruction Manual

FUNCTIONAL
DESCRIPTION
R
1 T
2
1. RESET (R) Button
2. Pilot lamp
3. TEST (T) Button
1
1. Wing bolt
2. Base
1
1. Wing nut
CAUTION:
• Always be sure that the tool is switched off and
unplugged before adjusting or checking function on the
tool.

Ground Fault Circuit Interrupter

003508
3
Connect the tool to a power supply and test the Ground Fault
Circuit Interrupter (GFCI) before using the tool. Push the
RESET (R) button and confirm that the pilot lamp lights.
Push the TEST (T) button and confirm that the pilot lamp
goes out. Push the RESET (R) button again to use the tool.
WARNING:
• Do not use the tool if the pilot lamp does not go out when
the TEST (T) button is pushed.

Adjusting the depth of cut

003510
Loosen the wing bolt on the depth guide and move the base
up or down. At the desired depth of cut, secure the base by
tightening the wing bolt.
2

Bevel cutting

003515
Loosen the wing nut on the bevel scale plate on the front of
the base. Set for the desired angle (0° - 45° ) by tilting
accordingly, then tighten the wing nut securely.
9