Installing The Refrigerator - GE CYE23TSDDSS Owner's Manual And Installation Instructions

Installation Instructions
l l,ll ii ,i,,,ul,,,,,u i llllli,Hll
INSTALLING THE REFRIGERATOR
REFRIGERATOR LOCATION
• Donot install the refrigerator where the temperature will
go below 60°F(16°C1 because it will not run often enough
to maintain proper temperatures.
• Donot install the refrigerator where the temperature will
go above 100°F(37°0 because it will not perform properly.
• Installit on o floor strong enough to support it fully loaded.
i,,, ii ii iiiiiiiiiiiiiiiiiiii i ii iiii ii ulllu,
CLEARANCES
Allow the following clearancesfor ease of installation, proper
air circulation and plumbing and electrical connections.
Sides i/8" (3 mini
Top 1"(25 mm) Cabinet/Hinge Cover
Back 2"150 mm)
REMOVINGTHE REFRIGERATOR DOORS
•tHPORTANTNOTE:This refrigerator is 361/4"deep (311/4"
for CYEmodels).Doors and passagewaysleading to the
1 "
installation location must be at least 36/4 wide in order to
leavethe doors and handles attached to the refrigerator
while transporting it into the installation location. If
passageways are lessthan 361/4 ", the refrigerator doors and
handles can easily be scratched and damaged. Thetop cap
and doors con be removed to allow the refrigerator to be
safely moved indoors. If passagewaysore lessthan 311/4",
start with Step 1.
° If it is not necessary to remove doors, skip to Step 11. Leave
tope and all packaging on doors until the refrigerator is in the
final location.
• NOTE:Use a padded hand truck to move this refrigerator.
Placethe refrigerator on the hand truck with a side against
the truck We strongly recommend that TWO PEOPLE move
and complete this installation.
iiiiiiiiiiiiiiiiiiiiiiiiii i i i _ i ii ii Ulllllll
I-_ REMOVE THE FRESH FOOD
DOOR HANDLE
Handle Design varies based on models, however
Installation is same.
Stainlesssteel and plastic handles:
O Loosenthe set screwswith the 1/8" Allenwrench and
remove the handle.
NOTEIfthe handlemountingfastenersneedto be tightenedor
removed,useo 1,/4" A llenwrench.
Mounting
Fasteners
\
Leavefilm
on until after
installation
[]
REMOVE THE FREEZER DOOR HANDLE
Handle Design varies based on models, however
Installation is some.
Stainlesssteel and plastic handles:
O Loosen the setscrewswith the 1/8"Allenwrenchand removethe
handle.
NOTE: I fthe handlemountingfastenersneedto be tightenedor
removed,useo .t!4"Allenwrench.
Mounting _
Fasteners
Leave film
on until afte_
installation
i
23
Reinstall the handles using the some
procedure us removing.
c , HUm,I